Countermeasure against deformation in L-shaped and U-shaped molded product

News Group

Countermeasure against deformation in L-shaped and U-shaped molded product

Issue Time:2020-08-11

Countermeasure against deformation in L-shaped and U-shaped molded product

（1） At the corner part, outside cooling will be faster than the inside, so this shape tend to deform towards the

inside direction.

（2） Remedying by placing the gate on the corner part is sometimes possible if it is GF reinforced grade.

（3） Lightening the corner inside part is effective. Make the recess part round, and do not make the sharp

corner.

（4） If there is no limitation, place a triangle rib towards the corner. Take the triangle rib from the high location

as possible, and the thickness have to be thinner than the half of the base.

（5） If the triangle rib cannot be placed to the inside, putting a T-shaped rib on the outside of the corner is

another method.

Fall down deformation of L-shaped molded product

（A） Gate placement to the corner part

（B） Recess of corner part

（C） Triangle rib

（D） Adding T-shaped rib

Figure 3-9 Fall deformation examples of L-shaped molded product

Previous Proper recycled material mix rate depends on the recycled material quality, using grade

Next Molding operation-Preliminary drying of materials ・Dryer

KeyWords

about

SUZHOU COSTAR MACHINERY CO.,LIMITED s an authorised company located in Suzhou city,the capital of china`s plastics machinery industry .suzhou also has an extensive sales netword based in the world.products include injection molding machines mold. . .

subscription